How to apply labels to vials
How to put a label from a roll onto a small glass vial so it sits straight and stays flat, step by step.
Before you start
Labels arrive on a roll with a backing strip, one after another. They stick best to glass that is clean, dry and at room temperature. A vial straight from the fridge collects condensation, and a damp surface stops the label gripping.
Step by step
- Wipe the vial. A dry, lint-free cloth is enough. Let it come to room temperature first if it has been chilled.
- Peel one label. Bend the backing strip away from the label so an edge lifts, then peel it off by that edge. Try not to touch the middle of the sticky side.
- Line it up. Hold the label level with the top of the straight side, below the shoulder, with the name facing you.
- Middle first. Touch the centre of the label to the glass, then smooth outwards to each end so it follows the curve without creasing.
- Press the edges. Run a thumb along all four edges, especially the two ends that wrap round the sides.
Getting them straight
If you’re labelling a batch, stand the vials in a row and label them all from the same height. If a label goes on crooked, lift it straight away, before you press it down, and try again. Once it has been pressed down, use a fresh one rather than peeling it.
Writing on labels
A write-on line gives you a printed rule to fill in by hand. Use a fine permanent marker, and try it on a spare label first: how well ink takes and how fast it dries depends on the label material.
What we can’t promise
We don’t promise freezer, cryogenic or chemical resistance. If your vials will be frozen, wiped with alcohol or handled wet, test one label in those conditions before you rely on a whole pack.
Order a pack to try
Pick a design, type your wording and see the label before you order. From $9 for 10.
Design your labels